Online HR-SD100 Solder Dross Separator Tin Dross Separating Machine

1.Characteristic:

1.Highly effective recycling of the solder waste, up to 90% yield .

2.No need to add any chemicals or reducers to the process uses physical separation to ensure a good quality product.

3.Button controls, digital temperature control sheet, accurate temperature control.

4.All-stainless steel tank, clean convenience.

5.316 grade stainless mixing bowl with an 10kg capacity with heating power for complete mixing.

6.Dross automatic feeding system, automatic feed screw.

7.Electronic liquid level alarm, manually put tin.

8.Automatic separation of tin and tin ash, into the tin and tin-ash collection device.

9.Small size, light weight, move convenience.

10.Independent smoke filtration system (Optional).

2.Technical parameters

Operation Steps

Ⅰ Start Up: Plug in and open up the power

Ⅱ Set Temperature Meter: (see temperature meter setting manual). Normally temperature set to 280℃, upper limitted is 300℃, lower limitted is 260℃. Machine goes into pre-heating status and it is costs about 40mins to reach the normal temerature.

Ⅲ Start UP: When temperature reaches set temperature, the green light turns on, press start button to start the mixing motor after it.

Ⅳ Operation: Feed the dross with continously, pls ensure that the dross should with the size of 20mm, big block of dross is not alowed. The machine can process 3-4kg dross every 20min, pls pay attention to the feeding time and frequency to ensure the seperation rate.

Ⅴ Stop Feeding: When the pure tin in the container reaches certain capacity, the alarm turns on, motor stops mixing in the same time and red light turns on to inform you releas the pure tin out. Press the Start button to turn off the machine and put the tin stick tray under the releaser and use the handle to open it. Press again the Start button to reoperate the machine after the pure tin comes out.

( Operator need to notic if the dust container full during operation, if it full, press Start button to stop mixing and clean out the dust container, re-start the machine after that.)

After separation

Our Service

1.Pre-consultation: provides professional SMT solutions for the full line.
2.Factory Warranty: One-year warranty factory service.
3.Installation: On-site installation and commissioning, to ensure smooth production.
4. Technical Training: provides professional training from Level 1 to Level 3.
5.Technical support:provides 7 * 24 technical support.
6.Software Upgrade: offers lifetime free software upgrades for all products.

Contact Us